Aarrow Fires Becton 7 mk3 Introduction Important Notices, Statutory Requirements, Certification

INTRODUCTION

IMPORTANT NOTICES

A qualified gas engineer must carry out the installation and servicing of this appliance in accordance with these instructions and in compliance with current Building Regulations.

Such person must be a registered CORGI engineer.

This appliance is designed to run on natural gas only. Warning - Only use the appliance with the specified gas.

The fire is fitted with a safety device to shut down the appliance if there is inadequate flue draw. If the fire shuts down for no apparent reason check chimney and air inlets to the room. In all cases the fire must not be re-lit until the safety aspects have been checked by a qualified gas engineer.

Please note the following;

•The safety device must never be put out of action.

•Sealed components must not be interfered with.

•Servicing instructions and part identification numbers are given towards the back of the manual.

•Only use genuine Aarrow parts for replacements.

•Ventilation, purpose built ventilation is not normally required for either appliance, normal adventitious room ventilation being sufficient.

•Coal Set, see safety notice on page 4.

All surfaces except the control knob, the control door handle and control door are considered to be working surfaces.

Warning: Under no circumstances must the fire be operated if the glass is cracked or broken.

Warning: If it is known or suspected that an operational or ignition fault exists on the appliance, it must not be used until it has been investigated and corrected by a qualified gas engineer.

Warning: THIS GAS APPLIANCE MUST BE SERVICED EVERY TWELVE MONTHS BY A QUALIFIED GAS ENGINEER.

STATUTORY REQUIREMENTS

The current Gas Safety (Installation and Use) Regulations (as amended).

The Building Regulations for England and Wales 2000 ref Approved Document J 2002 edition (issued by the DTLR).

The Building Standards (Scotland) (Consolidation) Regulations.

Detailed recommendations are outlined in the current issue of the following British Standards:- BS5440 parts 1 and 2, BS5871 part 1 and BS6891.

Any Manufacturer's Instructions must not be taken as overriding statutory requirements.

_________________________________________

CERTIFICATION

This appliance is CE certificated for performance and safety. Therefore, it is important that no alteration is made to the appliance.

Any alteration not approved by Aarrow Fires Ltd. will invalidate the guarantee.

Becton Bunny & Becton 7 mk3 Gas stoves 5