Chapter 3 | |
|
|
Primary.
Onboard Super IO Device:
This item can let you sets several items concerning the onboard super I/O device parameters.
Figure
Onboard FDD Controller:
Two options are available: Disabled or Enabled. The default setting is Enabled. This is used to enable or disable the Onboard FDD Controller. If you add a higher performance controller, you will need to Disable this feature.
Onboard Serial Port 1:
This item allows you to determine which I/O address the onboard serial port 1 controller will access. Six options are available: Disabled ) 3F8/IRQ4 ) 2F8/IRQ3 ) 3E8/IRQ4 ) 2E8/IRQ3 ) Auto ) Back to Disabled. The default setting is 3F8/IRQ4.
Onboard Serial Port 2:
This item allows you to determine which I/O address the onboard serial port 2 controller will access. Six options are available: Disabled ) 3F8/IRQ4 ) 2F8/IRQ3 ) 3E8/IRQ4 ) 2E8/IRQ3 ) Auto )Back to Disabled. The default setting is 2F8/IRQ3.
"UART Mode Select:
Three options are available: IrDA ) ASKIR (Amplitude Shift Keyed IR) ) Normal. The default setting is Normal.
"RxD , TxD Active:
Four options are available: Hi, Hi ) Hi, Lo ) Lo, Hi ) Lo, Lo. The default setting is Hi, Lo. Set IR transmission/reception polarity as High or Low.