English
78 | Appendix B Notices |
A-Tick notice
Apparatus Claims of U.S. Patent Nos. 4,631,603, 4,577,216, 4,819,098, and 4,907,093 licensed for limited viewing uses only.
For safety reasons, only connect headsets with a telecommunications compliance label. This includes customer equipment previously labelled permitted or certified.
The unit shall be connected to Telecommunication Network through a line cord which meets the requirements of ACA Technical Standard TS008.
Australian approved mains cord set shall be used with the equipment.
Regulatory information for 802.11b WLAN
Note: Below regulatory information is for models with 802.11b wireless LAN only.
Regulatory Information
The Wireless module must be installed and used in strict accordance with the manufacturer’s instructions. This device complies with the following radio frequency and safety standards.
Canada - Industry Canada (IC)
This device complies with RSS 210 of Industry Canada.
Europe - EU Declaration of Conformity
This device complies with the standards listed below, following the provisions of the EMC Directive 89/336/EEC:
•ETSI EN 301
•ETSI EN 300
USA - Federal Communications Commission (FCC)
This device complies with Part 15 of FCC Rules. Operation of the devices in an Wireless LAN System is subject to the following two conditions:
•This device may not cause harmful interference.
•This device must accept any interference that may cause undesired operation.