2-100 Service Guide
+2.35V:(2.45V) Load : 0A-4.2A Regulation: +5%, -4%
Ripple:50mA (max)
Noise: 100mV (max)
OVP: 3.3-5.0V
Short-circuit protection
Fuse protection
*Ripple(max)=75mV when regulate in IDLE mode
+12V : Load : 0A-0.15A Regulation: +/-5%
Ripple: 100mV (max)
Noise: 200mV (max)
OVP: 14-20V
*The +12V max load condition is available only when the +5V output load is greater than
0.5A.
+6V : Load : 0A~0.1A Regulation: 5.5V~7.5V
Ripple: 300mV (max)
Noise: 500mV (max)
OVP: 7-9 V
*The +6V max load condition is available only when the +5V output load is greater than
0.5A.
5VSB:Load : 5mA Regulation:+/-10%
Ripple: 75mV(max) Noise: 250mV(max)
P.G. :Active high within 100ms to 500ms after systems +5V, 3.3V and Vcpu are all in
regulation.
Driving capability:12uA(source) 200uA(sink)

2.10.4 Control

VCPU Control: Control switch can switch Vcpu output voltage to 2.35V2.45V2.9 or 3.1V. ON/OFF: A logic low will turn off +5V,+3.3V, 2.35V/2.45V/2.9V/3.1V,+12V and +6V
main o/p. The DC/DC converter draws about 30uA when the notebook computer is in
shutdown mode.

2.10.5 Application:

Input filter capacitor
The recommended value is two pieces of 10uf/50V ceramic capacitor(or the same grade
capacitor, such as SANYO OS-CON capacitor) with less than 150mohm ESR. And it should be
located less than 10mm away from DCBATT_IN pin.