Message

Description

 

Displayed

 

 

 

 

 

 

Microcode

BIOS could not find or load the CPU Microcode Update to the CPU. This message only

 

Error

applies to INTEL CPUs. The message is most likely to appear when a brand new CPU is

 

 

installed in a motherboard with an outdated BIOS. In this case, the BIOS must be updated

 

 

to include the Microcode Update for the new CPU.

 

 

 

 

NVRAM

There was an error in while validating the NVRAM data. This causes POST to clear the

 

Checksum

NVRAM data.

 

Bad, NVRAM

 

 

Cleared

 

 

 

 

 

Resource

More than one system device is trying to use the same non-shareable resources (Memory

 

Conflict

or I/O).

 

 

 

 

NVRAM

The NVRAM data used to store Plug??n??Play (PnP) data was not used for system

 

Ignored

configuration in POST.

 

 

 

 

NVRAM Bad

The NVRAM data used to store Plug??n??Play (PnP) data was not used for system

 

 

configuration in POST due to a data error.

 

 

 

 

Static

Two or more Static Devices are trying to use the same resource space (usually Memory or

 

Resource

I/O).

 

Conflict

 

 

 

 

 

PCI I/O conflict

A PCI adapter generated an I/O resource conflict when configured by BIOS POST.

 

 

 

 

PCI ROM

A PCI adapter generated an I/O resource conflict when configured by BIOS POST.

 

conflict

 

 

 

 

 

PCI IRQ

A PCI adapter generated an I/O resource conflict when configured by BIOS POST.

 

conflict

 

 

 

 

 

PCI IRQ

BIOS POST (DIM code) found a PCI device in the system but was unable to figure out how

 

routing table

to route an IRQ to the device. Usually this error is causing by an incomplete description of

 

error

the PCI Interrupt Routing of the system.

 

 

 

 

Timer Error

Indicates an error while programming the count register of channel 2 of the 8254 timer.

 

 

This may indicate a problem with system hardware.

 

 

 

 

Refresh timer

BIOS POST found that the refresh timer hardware failed to pass the Refresh Retrace Test.

 

test failed

 

 

 

 

 

Interrupt

BIOS POST could not initialize the Master Interrupt Controller. This may indicate a problem

 

Controller-1

with system hardware.

 

error

 

 

 

 

 

Interrupt

BIOS POST could not initialize the Slave Interrupt Controller. This may indicate a problem

 

Controller-2

with system hardware.

 

error

 

 

 

 

CMOS

 

 

 

 

 

Message

Description

 

Displayed

 

 

 

 

 

 

CMOS Date/

The CMOS Date and/or Time are invalid. This error can be resolved by readjusting the

 

Time Not Set

system time in AMIBIOS Setup.

 

 

 

 

CMOS Battery

CMOS Battery is low. This message usually indicates that the CMOS battery needs to be

 

Low

replaced. It could also appear when the user intentionally discharges the CMOS battery.

 

 

 

Chapter 4

50

Page 57
Image 57
Acer M5810 manual Cmos