39
Replacing the Lamp
Use a screwdriver to remove the screw(s) from the cover, and then pull out the lamp.
The projector will detect the lamp life itself. It will show you a warning message
"Lamp is approaching the end of its useful life in full power operation. Replacement Suggested!" When you see this message, change the lamp as soon as possible. Make sure the projector has been cooled down for at least 30 minutes before changing the lamp.
Warning: Lamp compartment is hot! Allow it to cool down before changing lamp!
| 3 |
|
| 9 |
|
|
|
|
|
|
| 1 |
|
|
|
|
|
| 2 |
|
| 4 |
|
| 10 |
| 5 |
|
|
| 1 |
|
| |
|
|
| 8 |
|
| |
| 1 | 2 |
| 8 |
| |
|
|
|
|
| ||
|
|
|
|
|
| |
2 | 12 |
|
|
| 6 | 7 |
|
|
|
| |||
11 |
|
|
|
|
|
|
1
12
To remove the lamp:
1 Turn the projector off by pressing 
(POWER).
2Allow the projector at least 30 mins to cool down.
3Disconnect the power cord.
4Use a screwdriver to remove the screws from the cover. (Illustration #1)
5Push up and remove the cover.
6Remove and dispose of the lamp protection film (Illustration #2).
7Remove the screw that secures the lamp module (Illustration #3).
8Pull out the lamp connector from a slot in the lamp compartment. Disconnect it from the projector (Illustration #4).
9Lift the handle so that it stands up (Illustration #5). Pull out the lamp module by force (Illustration #6).
To replace the lamp module, use a new lamp and follow illustrations # 7 - #112 .
Warning: To reduce the risk of personal injury, do not drop the lamp module or touch the lamp bulb. The bulb may shatter and cause injury if it is dropped.
