Acu-Rite 1036 instruction manual Display Unit Setup, Plug Power Adapter into Electric Outlet

Display Unit Setup

1 Set the A-B-C Switch 3 Write Down the MAC ADDRESS

The A-B-C switch is located inside the battery compartment. It can be set to A, B or C. However, you must select the same letter choices for both the sensor and the display unit in order for the units to synchronize.

2Plug Power Adapter into Electric Outlet

12 digit unique ID needed for online connectivity functions.

4Install or Replace Backup Batteries (optional)

Insert 6 x AA alkaline batteries into the battery compartment, as shown. Follow the polarity (+/-) diagram in the battery compartment.

1 A-B-C Switch set to match sensor

A B C

3	Write Down
	MAC ADDRESS		4	Install Backup
	12	digit number
				Batteries
				6 AA Batteries
				(optional)

2	Plug in Power
	Adapter
		IMPORTANT: Batteries are a backup
		power source to preserve records
		in the event of a power outage.
		Power adapter is the recommended
		primary power source to enjoy the full
		functionality of this product.

PLEASE DISPOSE OF OLD OR DEFECTIVE BATTERIES IN AN ENVIRONMENTALLY SAFE WAY AND IN ACCORDANCE WITH YOUR LOCAL LAWS AND REGULATIONS.

BATTERY SAFETY: Clean the battery contacts and also those of the device prior to battery installation. Remove batteries from equipment which is not to be used for an extended period of time. Follow the polarity (+/-) diagram in the battery compartment. Promptly remove dead batteries from the device. Dispose of used batteries properly. Only batteries of the same or equivalent type as recommended are to be used. DO NOT incinerate used batteries. DO NOT dispose of batteries in fire, as batteries may explode or leak. DO NOT mix old and new batteries or types of batteries (alkaline/standard). DO NOT use rechargeable batteries. DO NOT recharge non-rechargeable batteries. DO NOT short-circuit the supply terminals.

8