Provisioning LTPH-UM-1049-02, Issue 2
14 January 9, 2002 H2TU-C-319 List 4E
PROVISIONING TASKS
After the H2TU-C is successfully installed, perform these basic provisioning tasks:
•Set date and time (see “Setting Date and Time” on this page).
•Set circuit ID numbers (see “Setting Circuit ID Numbers” on page15).
•Make any configuration changes (see “Configuring the System” on page 16).
•Clear history, alarm, and event log screens to remove miscellaneous data during startup (see “Clearing the
History, Alarm, and Event Log Screens” on page3 3).

Setting Date and Time

Figure 4. Config Menu - Date and Time
1Press to select the Config menu.
2Use the and arrow keys to select Date and Time, then press .
3Type the date in the format indicated, then press .
4Type the time in the format indicated (entering seconds is optional), then press .
Monitor Performance Event Log Config Inventory Report Rlogon Help
+-----------------------+
| Standard Options -> |
| ADC Options -> |
| Test Mode -> |
|Date and Time ->|
+---------------------------------+
| Date (mm/dd/yyyy) : 08/01/2001 |
| Time (hh:mm[:ss]) : 06:40:11 |
+---------------------------------+
ID: xxxx--xxxx--xxxx--xxxx 08/01/2001 06:38:12 H2TU-C System: OK
C
↑ ↓ ENTER
ENTER
ENTER