Provisioning LTPH-UM-1049-02, Issue 2
16 January 9, 2002 H2TU-C-319 List 4E
Configuring the System
The Config menu (see Figure6 below) allows you to make the following changes:
•Standard options (see “Making Changes to Standard and ADC Options” on page 16).
•ADC options (see “Making Changes to Standard and ADC Options” on page16).
•Date and time (see “Setting Date and Time” on page 14).
•Master clear (see “Clearing the History, Alarm, and Event Log Screens” on page33).
•Reset to factory default configuration (see “Resetting to Factory Defaults” on page32).
Figure 6. Config Menu

Making Changes to Standard and ADC Options

Figure 7 and Figure8 on page 17 show the Standard and ADC configuration options. Standard options are those
supported by HiGain HDSL2 units when connected to units from other vendors. ADC options are an extended set
of options that are only available when using HiGain units exclusively. For a description of each option and a list
of possible option settings, refer to Table 5 on page18 and Table 6 on page19. To make changes to these options:
1Press to select the Config menu.
2Use the and arrow keys to select Standard Options or ADC Options, then press .
3Use the arrow keys to select an option.
4Press the to cycle through the available settings for that option.
5Press to activate your choice.
Monitor Performance Event Log Config Inventory Report Rlogon Help
+-----------------------+
|Standard Options -> |
| ADC Options -> |
| Test Mode -> |
| Date and Time -> |
| Master Clear |
| Set Factory Defaults |
+-----------------------+
ID: xxxx--xxxx--xxxx--xxxx 08/01/2001 06:38:12 H2TU-C System: OK
C
↑ ↓ ENTER
SPACEBAR
ENTER