ADCP-80-575 • Issue 2 • December 2006
1.4Packaged Hardware
The fuse platform is shipped with hardware components (shown in Figure 2) that are packaged separately and enclosed in the same carton. The packaged hardware components include the following items:
•Two sets of mounting brackets (for 19-inch or 23-inch rack mounting)—Used to mount the panel on the equipment rack.
•5/16-inch long, Phillips drive, 8-32 flat-head thread-forming screws (8)—Used to secure the mounting brackets to the panel.
•3/8-inch long, combination drive, 12-24 pan-head screws (4) and #12 flat washers (4)— Used to secure the mounting brackets to the equipment rack.
•#10 ring terminals (2) for 12–10 AWG wire—Used to connect the grounding cables to the grounding studs.
•Rear protective input terminal covers and output terminal covers—Used to prevent accidental contact with the power input and output terminals. The number of covers provided depends on the fuse configuration.
•Designation card and card holder—Used to record information about the protected equipment. The card holder has a pressure-sensitive adhesive backing to permit attachment to the panel, the rack, or a location close to the panel. The designation card inserts into the card holder. It is also available as an accessory item.
Page 4
© 2006, ADC Telecommunications, Inc.
