Adcom GTP-760 owner manual Digital Audio/Standard Composite Video Inputs

For FM, use either the 75 ohm “F” connector or the 300 ohm “push terminals” depending on what type of antenna you’ve chosen. If you’re getting FM from a cable system feed, you will most likely use the “F” connector. The “T” shaped antenna supplied with the GTP-760 uses the push terminals marked “300 ohms.” “T” antennas are directional. They should be placed as high as possible with the arms fully extended. If possible, the arms should be oriented so that they are at right angles to the transmitter.

signal direction

transmitter

signal direction

transmitter

best reception

poor reception

FM antenna

to GTP-760 FM antenna connection

The supplied AM loop antenna connects to the push terminals marked “ground” and “AM,” respectively. You may need to adjust the position of the antenna for best reception. If you use an outdoor AM antenna, follow the manufacturer’s instructions.

19 Digital Audio/Standard (Composite) Video Inputs

Remember that you must choose either standard (composite) or S-Video connections before hooking up source components. This section of the manual assumes you have chosen composite connections. S-Video connections will be handled in a subsequent section.

DVD in: Connect the DVD player’s composite video output to the yellow-center RCA jack immediately under the “DVD in” label.

Connect the DVD player’s RCA-style digital output jack to the GTP-760’s black-center RCA jack located under the “DVD in” label.

Note: If your DVD player has only a TOSlink (optical) digital output, you may need to connect it to “dig.2 in.” If this is the case, remember to connect the player’s video output (composite or S-

11