Adcom GTP-760 owner manual Product Features, Front Panel Controls

1.0PRODUCT FEATURES

1.1Front Panel Controls

The GTP-760’s front panel is a model of simplicity. All controls are logically grouped for easy, intuitive operation. Familiarize yourself with the following diagram and read the short explanations of each feature. When you finish, you will be well on your way to enjoying the GTP-760’s convenience and sound quality.

3 3 7 6 8 14 15

D I G I T A L

G T P - 7 6 0

p h o n e s

D T S

D o l b y D i g i t a l C i n e m a

D o l b y P r o L o g i c s y m p h o n y h a l l s t a d i u m

j a z z c l u b

5 - c h a n . s t e r e o 2 - c h a n . s t e r e o

D I G I T A L

S U R R O U N D

f u l l

7 5 %

5 0 %

2 5 %

s u r r o u n d m o d e

d i a l o g e n h a n c e

d y n a m i c r a n g e

RDS PROGRAM TYPE AM FM STEREO SEEK VOLUME MUTE PRESET 18

1	2	3	4	5	6	7	s h i f t ( 8 - 1 4 )
F M / A M s e e k / m a n u a l		<	t u n i n g	>		d i m	5 . 1 - c h a n n e l i n

D V D	d i g i t a l 1	d i g i t a l 2
L D	V C R	v i d e o a u x
C D	t a p e	t u n e r	r o o m 2

1 2 5 4 9 10 11 12 13 14 16 17

1Headphone Jack: This accepts the stereo 1/4" phone plug connector used by almost all high quality headphones. When you use the headphone jack, the GTP-760’s rear panel main line level Preamp outputs are muted. Room 2 outputs are NOT affected.

2Power Button and LED: Use this button to turn your GTP-760 ON and OFF. When you first push the Power Button to the ON (depressed) position, the center LED will glow yellow until all circuitry stabilizes. When your GTP-760 is ready to use, the LED will turn red.

NOTE: The front panel Power Button must be engaged to use the remote control. If the front panel Power Button is not depressed, the remote control will not have any effect. When the front panel Power Button is engaged, the remote controller’s “Power” button will cycle your GTP-760 between standby and operation modes. When in standby mode (indicated by the yellow LED), you need to press the remote control’s “Power” button to activate your GTP-760’s circuitry (the LED will turn red when you do this).

3Surround Mode Button and LED Indicators: Pushing the button sequentially steps your GTP-760 through all the available operating modes for the selected input. The modes that are not available for the current operating state are automatically bypassed.

For the 6 analog inputs, the choices are always the same - Dolby Pro Logic, Dolby Pro Logic/ Cinema, symphony hall, stadium, jazz club, 5-chan. stereo, and 2-chan. stereo.

For digital inputs (DVD, digital 1 and digital 2) the choices are dynamic and depend on the type of signal being input.

For DTS signals, the choices are DTS, DTS/Cinema and DTS/2 chan. stereo.

For Dolby Digital 5.1 channel signals, the choices are Dolby Digital, Dolby Digital/Cinema and Dolby Digital/2 chan. stereo.

6