WAC 5 6 8 USER MAN final 3/2/05 12:23 PM Page 13
OPERATING INSTRUCTIONS
Mechanical control model
MODE
The mode knob controls fan speeds and cooling speeds. To set desired cooling temperature, simply rotate the mode knob dial to the appropriate setting. See Fig. 9.
THERMOSTAT
The thermostat automatically controls the cooling cycle (compressor) of the air conditioner to maintain room temperature. However, the fan motor will continue to operate after the compressor (cooling cycle) is completed. See Fig.9.
LOW FAN will circulate the air at a minimum speed without cooling.
HIGH FAN will circulate the air at a maximum speed without cooling.
LOW COOL provides cooling, automatically with minimum air circulation. Recommended for night- time use.
HIGH COOL provides cooling, automatically with quick cooling or for extremely hot days. Once room is cooled, reduce setting to LOW COOL.
OFF will completely
NOTE: After setting the mode, allow 3 minutes before switching to another mode.
Thermostat knob
Mode knob
Fig.9
! CAUTION !
When using FAN control, turn slowly allowing unit to adjust.
When using THERMOSTAT, be sure to allow three minutes before changing temperature. Adjusting too quickly may cause an overload resulting in a blown fuse.
Fresh Air Ventilation is usually kept in the closed position. Use only when clearing smoke and/or odors from the room. Pull to open. (See Fig.10).
Fresh Air |
Vent Lever |
Fig.10 |
11