WAC 5 6 8 USER MAN final 3/2/05 12:23 PM Page 9
TIPS BEFORE INSTALLATION
Your Room Air Conditioner unit is designed to
be highly efficient and save energy. Follow these recommendations for greater efficiency.
1.Select thermostat setting that suits your comfort needs and leave the thermostat at that chosen setting.
2.The air filter is very efficient in removing airborne particles. Keep the air filter clean. Typically, filter should be cleaned once a month. More
frequent cleaning may be necessary depending on outdoor and indoor air quality.
3.Use drapes, curtains, or shades to keep
direct sunlight from heating your room, but
DO NOT obstruct the air conditioner. Allow air to circulate around the unit without obstructions.
4.Start your air conditioner before outdoor air becomes hot and uncomfortable. This avoids an initial period of discomfort while the unit is cooling off the room.
5.When outdoor temperature is cool enough, use HIGH or LOW FAN only. This circulates indoor air, providing some cooling comfort, and utilizes less electricity than when operating on a cooling setting.
Your Room Air Conditioner was designed
for easy installation in a single or
! CAUTION !
To avoid installation/operating difficulties, read the instructions thoroughly.
NOTE: Save the shipping carton and packing materials for future storage or transport of the unit. Please check the contents of the hardware kit against the corresponding model check list, prior to installation of the unit.
See lists below.(Fig.1)
Installation Hardware
3/4"Screws (12) | Seal(1) |
2/5"Screws (8) | Foam(1) |
| |
Top Channel(1) |
|
factory installed | Side Curtain RH(1) |
|
Side Curtain LH(1)
L Bracket(2)
Side Bracket(2)
Fig.1
NOTE: Surplus screw(s) for spare use.
Tools Needed for Window Installation
Screw drivers: Both Philips and flat head
Power drill: 1/8 inch diameter drill bit Pencil
Measuring tape Scissors Carpenters level
7
