ADTRAN 610200094 Interface Connectors, I35MB Installation, pinconnector, pinPower, Introduction

Adtron I35MB Operations Manual

Interface Connectors

The I35MB has an interface connector located on the front panel. Using an 80- conductor cable (40-pin connector); connect the I35MB to the primary or secondary ports on the IDE controller. Plug a power cable from the computer’s power supply into the I35MB power connector. The I35MB does not require 12V. Refer to the Figure below, for the location 40-pin connector and power supply.

40-pin connector	4-pin Power
	connector

Figure 5 I35MB interface

I35MB Installation

Introduction

The I35MB is a 3.5-inch hard disk drive and mounts into a standard 3.5-inch hard disk drive bay. The drive may be mounted from the side or the bottom.

DO NOT exceed the maximum insertion depth of 3.8mm [.150”] from drive edge. Consider the length of the screw used and thickness of the mounting surface. A common screw length of 3/16” is provided, but may not be correct in all applications.

Refer to Figure 6 on page 5 for mounting hole locations.

Static Sensitive - The I35MB is a static sensitive device. When installing and uninstalling the I35MB, take precautions to ensure that static does not discharge into the I35MB.

4 Rev. 003, PN: 610200094