Adtron I35MB Operations Manual
Rebuilding the faulted drive may take several hours, depending on the size of the media and may result in a hard fault if the drive cannot “map” around any “bad” sectors. While rebuilding can result in a reliable storage device and workable drive, Adtron recommends replacing the drive in the field that exhibits a soft fault and then rebuilding and testing this drive in a non- critical test environment to determine if this drive can be used as a spare.
Turning the Buzzer Off
The audible buzzer goes off when a hard fault occurs on one of the two disk drives. When a hard fault occurs, the
To turn the buzzer off:
1.If possible, pop the removable plastic panel off the drive bay in which the I35MB is installed. If the I35MB does not have front access through a drive bay, continue with Changing Media on this page.
2.Depress the Buzzer Reset button, labeled S4 in Figure 7 on page 7.
3.Note the bank number, 0 or 1, with the fault LED turned solid orange. This is the bank that requires attention.
4.Schedule a time to power down the computer and remove the I35MB.
Changing Media
Static Sensitive - The I35MB is a static sensitive device. Take precautions to ensure that static does not discharge into the I35MB.
To change the bank with the fault:
1.Make sure you are appropriately grounded.
2.If accessible from the front cover, pop the faceplate off the bay with the I35MB inserted. Push the Buzzer Reset button (S4) on the I35MB to turn off audible alarm, if applicable.
10 | Rev. 003, PN: 610200094 |
