ADTRAN 610200094 manual Inserting the I35MB

Adtron I35MB Operations Manual

Inserting the I35MB

To install the I35MB in the hard disk drive bay:

1.Power down the computer and remove the cover.

2.Make sure that you are properly grounded.

3.Set the master/slave to desired configurations. By default, the I35MB is set to master.

4.Select a 3.5-inch drive bay that houses either a floppy or hard disk. If the chassis provides a front removable panel, the buzzer reset and fault LEDs can be viewed by removing the plastic panel on the chassis.

5.Using an 80-conductor cable (40-pin connector) connect the I35MB to the IDE primary or secondary IDE ports.

6.Connect the power supply to the I35MB.

7.Mount the I35MB into the appropriate disk drive bay, using screws to secure the I35MB in the chassis. See Figure 6 for mounting holes, screw size and maximum depth.

8.Put the cover on the chassis and screw it down.

9.Power on the computer.

„

6-32 x 3.8mm[.150"] MAX. DEPTH

Figure 6 Mounting Holes

5 Rev. 003, PN: 610200094