Adtron I35MB Operations Manual
12.Before the disk drive is fully seated (approximately ¼ of an inch to the drive being fully seated)
13.Tighten the retaining screw for the new disk drive.
14.The I35MB may be
15.After securing the I35MB, a rebuild must be performed. Go to Rebuilding a Bank on page 13.
Resetting Mirroring Indicators
The procedure below provides steps to reset the mirror indicators on the I35MB. These steps address mirror indicators and DO NOT address resetting mirroring data or data equilibrium. In addition, following these steps will only ensure subsequent writes will be mirrored. For more information on resetting mirroring operations beyond mirror indicators, refer to the section of this manual titled, Rebuilding a Bank, on page 13.
Static Sensitive - The I35MB is a static sensitive device. Take precautions to ensure that static does not discharge into the I35MB.
To reset mirror operations and change both banks:
1.While power is OFF, verify both banks are unpopulated.
2.Cycle the I35MB power to the ON state (for 5 seconds or more), then the OFF state.
3.Insert media into desired banks.
4.Cycle power ON.
5.Once powered ON, all subsequent writes will be mirrored.
12 | Rev. 003, PN: 610200094 |