Advantech TPC-1260 manual Mounting, Panel mounting

Figure 1.6-1 I/O ports arrangement

1.7 Mounting

1.7.1Panel mounting

1.There is a piece of adhesive waterproof gasket on the Mg-Al front bezel. Make sure the waterproof gasket is in position before install the TPC-1260 to the panel opening.

2.Install the TPC-1260 to the panel opening.

3.Find out the eight clampers and eight long screws in the accessory pack. Hook those clampers to those holes around the four sides of the bezel. Insert the screws to every clamper and fasten them. These screws will then push on the mounting panel and fix the unit.

4.The mounting panel thickness is suggested to be less than 6mm (0.236 inch).

<6mm

Figure 1.7-1 Panel mounting

Chapter 1 General Information 7