Advantech TPC-1260 manual Insert a new CPU board to the SO-DIMM connector

Step 4: The CPU board is now visible. It connects to the I/O board by a 144-pin SO-DIMM connector and a 50-pin FPC connector.

Step 5: Use a pair of tweezers to loosen the 50-pin FPC connector, and release the FPC.

Step 6: Bend outward the two metal latches of the SO-DIMM connec tor by thumbs. The free end of the CPU board would swing up. Pull out the CPU board.

Figure 6.1-3 Remove the CPU board

Step 7: Insert a new CPU board to the SO-DIMM connector.

Step 8: Push down and lock the CPU board.

Step 9: Use a pair of tweezers to insert the 50-pin FPC to the connector on the CPU board. Then tighten the connector.

Step 10: Replace the CPU board cover and fasten the screw.

Warning: The CPU cover is used as the cooling media of the CPU. Thus it is usually of higher temperature than other parts of the system. Be careful not to touch this area without proper protection.

Chapter 1 General Information 4 7