Starting a programme
1.Check that the water tap is open.
2.Press the START/PAUSE key.
The programme is started or it starts after the time delay set has elapsed.
3If after pressing the START/PAUSE key the display shows “Door not Closed”, the door has not been shut properly. Push the door firmly closed and press the START/PAUSE key again.
Programme progress
The display indicates the stage of the programme that is currently being performed as well as the time to the end of the programme.
LINEN/EASY CARE | 12.45 | |
Washing | 14.37 | |
50C 800 | aýýýýýaýaýaýaýaýaýaýaýa | |
|
|
|
TEMP. | RPM OPTIONS OK | TIME |
3During the wash cycle the
time to the end of the pro- gramme may change as the
programme adjusts itself to different conditions (e. g., type and quanti- ty of laundry, out of balance spin detection, special rinses, etc.).
Interrupting a programme/Adding washing
Interrupting a programme
•The programme can be interrupted at any time by pressing
the START/PAUSE key. It is then
•To stop the washing machine before the programme has ended, turn the programme knob to OFF.
Attention! Be careful if there is water in the appliance!
Adding washing
1.Press the START/PAUSE key.
•If “Door locked” and “Pause” are alternately shown in the display, it is no longer possible to add washing, e. g. when the water level is too high.
•If “Door openable” and “Pause” are alternately shown in the display, it is still possible to add washing:
2.Open the door.
3.Add washing and close the door again.
4.Press the START/PAUSE key again. The programme continues.
19
