Water Drainage

4.Connect the hose to a tap with a

3/4” thread.

Always use the hose supplied with the appliance.

The appliance drain hose should hook into a standpipe, the hook in the drain hose is formed using the plastic “U-Piece“ supplied. The standpipe should have an internal diameter of approximately 38 mm (see dia- gram) thus ensuring there is an air break between the drain hose and standpipe.

Important! It is essential to lay the drainage hose without kinks. When discharging into a stand-

pipe ensure that the top of the curve in the hose end is no more than 90 cm (35.4’’) and no less than 60 cm (23.6’’) above floor level.

The upright standpipe should have a minimum, length of 30 cm (12’’) from the bottom of the el- bow to the top of the pipe (see diagram). Make sure that it is de- signed in such a way that the end of the drain hose cannot be cov- ered with water.

Longer drain hoses are available in lengths of 2.7 and 4 metres from your Service Force Centre.

Page 41

Image 41

Contents

Lavamat Dear Customer Following symbols are used in the text Contents Safety information concerning installation Installation and connection instructions Prior to using the appliance for the first time SafetyChild safety General safety Resulting overheating may constitute a fire hazard Cycle end at What is shown in the display Easy Iron Program overview Use/Features Care Symbols1 N g u a g e Prior to using for the first timeR a c h e Programmende um Preparing and sorting washing Setting the timeCarrying out a wash programme prior to first use Preparing washing Adding detergent/conditioner Running a wash cycleOpening the door/Loading the washing Washing powder/tablets for the main wash cycle Switching on the appliance/selecting a programmeIf you are using liquid detergent With spin speed 0 the TEMP. RPM Options OK Time Changing spin speed/selecting rinse holdSpeed or Rinse Hold is displayed Setup Setting options Prewashing To switch off the optionSensitive Prewash, Sensitive, Stain, Night Cycle Delay Start Setting timesTime saving Time Saving Short or Very Short Start in 4h Delay StartStart Press the OK key. Start in 0 min is shown in the display Starting a programme WashingProgramme progress Interrupting a programme/Adding washing If Rinse Hold or Night Cycle was selected SetupWashing cycle complete/Removing the washing Memory Store program Setting the MemoryMemory 1, 2 Changing the Memory Extra Rinse U n dN s e + Clock Set timeLanguage Desired setting. With Child safety deviceContrast and brightness Each press of the key or if Cleaning procedure Cleaning and maintenanceDeactivating the child safety device Detergent dispenser drawer Washing drum Clean the glass in the door and the rubber collar regularlyDoor and rubber collar Top of the washing-in chamber, with a brush Remedying small malfunctions What to do if Adjusted There are grey stains on the washing If the wash result is not satisfactoryFoam can still be seen following the final rinse There are white residues on the washing Carrying out an emergency drain When the water has all drained away Drain pump Old appliance DisposalPackaging material Consumption values Technical data Installing the appliance Safety information concerning installationTransporting the appliance This washing machine cannot be built-in Remove the power supply cable When using a sack trolley to transport the washing machineUnpacking Only use the sack trolley on the side of the appliancePage Where to install Making the appliance level Electrical Connection Permanent Connection Brown Live Wire coloured green and yellow Permitted water pressure Connecting to the water supplyWater inlet Open the porthole and extract the inlet hose Water Drainage For drainage into an outlet Pumping heights of over 1 metre Great Britain Guarantee/Customer Service European Guarantee LU4 9QQ Slovenija Customer Care 0870 5 929For general enquiries concerning Major Appliances 132 977 Subject to change without notice

AEG 86810 manual Water Drainage

Models: 86810

Water Drainage