AEG CG 6400 manual Using pre-ground coffee, Function. The appliance displays e.g

g

In the upper line, the display shows the

coffee strength as set in the "Jug" menu, e.g. «EXTRA-MILD JUG». The

lower line of the display shows the scrolling keys "<" or ">" and the number of cups to be poured into the jug, i.e. «< > 4».

3If you wish to change the strength and size of the cups for the jug function, proceed as described in the section „Setting the jug program (coffee strength and fill level for jug function)“, page 47.

0If necessary, press the scrolling keys "<" or ">" to increase or decrease in steps of 2 cups the number of cups you wish to pour into the jug (4, 6, 8, 10 cups).

3If no keys are pressed within a few sec- onds, the appliance will suggest the next step in the display: «CHOOSE NUMBER OF COFFEE, PRESS JUG KEY».

0Once you have chosen the desired number of cups, confirm this by press-

ing the "JUG" key (Fig. 19). The display shows an advancing progress bar with a percentage indica-

tion

«40%» which represents the status of the brewing operations.

Once the progress bar is complete and the percentage has reached 100%, the appliance stops brewing, and returns automatically to the coffee mode.

0Now you can remove the thermos jug and close the lid (Fig. 20) to keep the coffee warm for a longer period of time.

3If there are not enough coffee beans to complete the requested operation, the machine will stop the operation and wait until the coffee bean container

has been filled and the "JUG“ key (Fig. 19) has been pressed. For instance, if you program 8 cups but you have only beans for 6 cups, the appliance will deliver 6 cups and then stop. Fill the coffee bean container and then

press the "JUG“ key (Fig. 19). Once you have done this, the appliance will deliver just the last 2 cups, to reach the programmed quantity of 8 cups.

If there is either too little water to complete the requested operation, or the waste coffee container is full, the machine will stop the operation. The jug has to be removed to fill the water tank or to empty the waste coffee con- tainer; at this point, the current pro- gram is cancelled. After the error has been rectified, the program must be restarted. The amount of coffee already in the jug must be taken into consideration, so that the jug is not over-filled.

3If the message «GROUND TOO FINE ADJUST MILL

AND TURN KNOB» is displayed, the coffee is ground too fine. You should change the grinding setting; see „Set- ting the grinding texture“, page 46.

9 Using pre-ground coffee

This function allows you to brew pre- ground coffee, e.g. decaffeinated coffee.

1Make sure that no ground coffee has remained in the filler, and that no for- eign objects enter the filler. The ground coffee filler is not a storage container. The ground coffee must be fed directly into the brewing unit.

0Turn the "Coffee strength / Pre-ground coffee" knob (Fig. 21) to the desired

position (for 1 cup) or (for 2 cups) to select the pre-ground coffee function. This disables the coffee mill

function. The appliance displays e.g.

«ESPRESSO CUP PRE-GROUND 1 CUP».

0Open the lid of the ground coffee filler, and scoop in the fresh ground coffee (Fig. 22).

Use only the supplied measuring spoon. Never add more than 2 level measured scoops, otherwise either the

43