AEG CG 6400 manual Filling with water, Switching on for the first time, «Turn Steam Knob»

g

6.2Filling with water

Each time before switching on the cof- fee machine, check that there is water in the water tank, and refill if neces- sary. The coffee machine requires water for the automatic rinsing processes each time the machine is switched on or off.

0Remove the water tank from the cof- fee machine (Fig. 6). Before the tank is removed, the steam nozzle must always be positioned towards the cen- tre of the appliance, otherwise the tank cannot be removed.

0Fill the water tank with fresh cold water. Never exceed the MAX line.

3Pour only fresh cold water into the water tank. Never put in other liquids, e.g. mineral water or milk.

0Replace the water tank (Fig. 6). Press the tank firmly in, to ensure that the water tank valve opens.

3To always be sure of obtaining a rich coffee with a full aroma, you should:

–change the water in the water tank daily,

–wash the water tank at least once a week in normal washing-up water (not in the dishwasher). Then rinse with fresh water.

6.3Filling the coffee bean container

0Raise the lid of the coffee bean con- tainer, and fill the container with fresh coffee beans (Fig. 7). Then reclose the lid.

1Note! Make sure that no foreign objects, such as stones, enter the cof- fee bean container. Damage caused by foreign objects in the grinder is excluded from the guarantee.

3The grinder is factory-set to a medium grinding texture. If necessary, you can change this setting. Notes on changing the grinder setting can be found in „Setting the grinding texture“,

page 46.

1The grinder settings may be changed only whilst coffee is being ground. Making adjustments to the stationary grinder can damage the coffee machine.

3Coffee has been used to factory-test the appliance, and it is therefore com- pletely normal for there to be traces of coffee in the mill. This appliance is however guaranteed to be new.

6.4Switching on for the first time

When you operate the machine for the first time, the automatic switching on process only continues if you have selected the desired language.

0Switch on the machine with the main switch on the rear of the machine (Fig. 8).

The display shows the text «PRESS MENU TO CHOOSE ENGLISH»

successively in all available languages.

0Wait for the correct language and press the "Menu" key to confirm

(Fig. 4) and keep it pressed until the display shows: «ENGLISH INSTAL- LED».

3After using the machine for the first time you can change the language at any time; see „Setting the language“, page 46.

After programming the language, the display shows «FILL TANK !».

0Fill the water tank; see „Filling with water“, page 38.

0Replace the water tank (Fig. 6). Press the tank firmly in, to ensure that the water tank valve opens.

The display now shows:

«TURN STEAM KNOB»

0Move the steam nozzle outwards and place a cup underneath it (Fig. 9).

0Turn the knob for steam and hot water anticlockwise as far as it will go to the

position (Fig. 10).

After a few seconds, a little water runs out of the steam nozzle and the display shows a progress bar. When the cup contains about 30 ml of water, the

38