AEG CG 6400 manual Frothing milk, AND TURN KNOB» will be dis- played

g

appliance will not make the coffee, the ground coffee will be dispersed inside the appliance, dirtying it, or the coffee

will be delivered drop by drop and the message «GROUND TOO FINE ADJUST MILL

AND TURN KNOB» will be dis- played.

Do not add ground coffee during the brewing process. Only put in ground coffee for the next cup when the brewing process has completely fin- ished and the coffee machine is ready. Never add the ground coffee when the appliance is off, as otherwise it will be dispersed inside the appliance.

1Use only ground coffee for fully auto- mated espresso coffee makers. Do not put coffee beans, any water-soluble or freeze-dried instant products or any other drink powder into the ground coffee filler. Coffee powder which is too fine can lead to blockages.

3If the filler shaft is blocked (due to moisture inside the appliance, or because more than 2 measuring scoops of pre-ground coffee have been used), use a knife or a spoon handle to push the coffee down (Fig. 23). Then remove the brewing unit and clean it and the appliance as described in the section „Cleaning the brewing unit“, page 51".

0Close the lid.

3If you do not activate any key within few seconds after having selected the "Pre-ground coffee" function, the

appliance will suggest the next step in the display: «PRESS 1 OR 2 CUPS KEY»

0To choose the required cup size, turn the knob for "Cup size" (Fig 13). The selected cup size will be displayed.

0Press the key for "1 cup" to make

one cup, or the key for "2 cups" to make 2 coffees.

The coffee is prepared.

3Once the coffee has been prepared, to go back to making coffee using beans, turn the "Coffee strength / Pre-ground coffee" knob (Fig. 21) to any coffee strength setting (the coffee mill is ena- bled for operation again).

10 Frothing milk

The steam can be used to froth milk and to heat liquids. Since a higher temperature is needed to produce steam than to make coffee, the coffee machine has an additional steam mode.

3To make a cappuccino, fill a large cup 1/2 to 2/3 full with espresso, and then add the frothed milk.

1Caution! Danger of scalding when the steam nozzle is activated! Hot water or steam output can cause scalding. Do not activate the steam nozzle until it is immersed in the milk.

0To produce steam, press the "Steam" key (Fig. 24).

The display shows «HEATING UP…» in the upper line and in the lower line an advancing progress bar with a per-

centage indication

«40%».

When the heating process is finished, the display shows «STEAM». The

machine is ready for the milk frothing.

3If you do not perform any further action within a few seconds after the message «STEAM» is shown on the

display, the appliance will suggest the next step, showing «STEAM» in the upper line of the display and «TURN KNOB FOR STEAM» in the lower line.

3If the steam function is not used for longer than 2 minutes, the machine switches back automatically to the coffee mode.

44