AEG DF6260-ML/1, DF 6160, CHDF 6260 Removing the hood from the wall unit

Removing the hood from the wall unit

If, for technical reasons (extraction version/recirculation version conversion) the extractor hood has to be removed from the wall unit, proceed as follows:

•Fully withdraw the visor and remove the grease filter.

•Loosen the 4 or 6 mounting screws of the hood (wall unit mounting).

•To loosen both mounting claws (installation aids), place a max 3 mm dia. Phillips screw-driver in the spring opening and simultaneously press the springs inwards (towards the appliance housing). Fig. 14.

Fig. 14

Important: Hold the hood firmly!

Adjusting the extractor part (E - Fig. 1) - Fig. 15

On wall units with a body depth of 275 mm to 335 mm, the visor depth can be adjusted as follows:

•Remove both grease filters.

•Loosen the screws on both end-stop brackets and set the visor depth (min. 275 mm, max. 335 mm).

•Refit the screws.

•Refit the grease filters.

Fig. 15

75