Kyocera NX instruction manual Troubleshooting, Symptom Cause Solution See

2. Troubleshooting

If there seems to be a problem, check the following table before assuming the camera is malfunctioning.

Symptom		Cause		Solution	See page
1. Nothing appears	•	No battery is	•	Insert battery.	16
on the display		loaded.
panel	•	Battery is fully	•	Replace the bat-	16
		spent.		tery with a new
				one.
	•	Battery is loaded	•	Insert the battery	16
		upside-down.		properly.
2. Battery mark	•	Battery is spent.	•	Replace the bat-	17
(“ ”) is flashing				tery with a new
				one.
3. Exposure counter	•	Film has not been	•	Reload the film.	20
flashes “00” when		advanced proper-
film is loaded and		ly.
camera back is
closed
4. Viewfinder display	•	Diopter is not	•	Turn the diopter	15
is not clear		properly adjusted.		adjustment dial to
				adjust.
5. Shutter cannot be	•	Drive mode is set	• Switch to a differ-		31
released		to the “selftimer”		ent drive mode.
		mode.
	•	Internal flash is	•	Wait until charging	73
		charging.		is complete (i.e.
				“ ” lit) before tak-
				ing the photo-
				graph.

Symptom		Cause
6. Photographs are	•	Focus is not prop-
blurry		erly adjusted.
	•	Camera is shak-
		ing when shutter
		button is pressed.
	•	Shutter speed is
		slow.
7. Exposure com-	•	Exposure com-
pensation mark is		pensation is still
displayed.		set.
8. Shutter speed or	•	Subject is either
aperture value		too bright or too
flashes during auto		dark.
photography
9. Exposure counter	•	ABC mode is set.
is flashing (other
than “00”)
10. Metering mark	•	“AE lock on”
flashes when		selected when
shutter button is		half-pressed.
half-pressed

	Solution	See page
•	Adjust the focus	38
	properly.
•	Press the shutter	19, 27
	button gently so
	that the camera
	does not shake.
•	Use a tripod.
•	Set the exposure	58
	compensation
	back to “0.0”.
•	Turn the main	58
	switch OFF.
•	Adjust the expo-	54
	sure as described
	on page 54.
•	Set ABC compen-	62
	sation back to
	“0.0”.
•	Set custom func-	87
	tion to “2-0”.

92 93