Kyocera NX instruction manual Setting custom functions, Set the position dial to CF

2. Setting custom functions

Detail number

Function number

Superimpose when focused

Standard set-	Changed set-	Changed set-		Changed set-
ting (0)	ting (1)		ting (2)		ting (3)
On	Off

Display panel

Detail

Set the position dial to “CF”.

The display panel is as shown at left (custom function setting mode).

Rewind auto return

Leave film tip when rewinding

Selection of aper- ture stop-down button operation

Focus button function in “MF” mode

Red-eye reduc- tion with internal flash

Exposure com- pensation setting (with Av, P)

Exposure value display when zoom lens is fitted (*)

Continued exposure compensation

Exposure com- pensation setting

Auto return on

Film tip not left

Aperture

stopped down while pressed

SAF

Off

F dial

Align aperture

ring

Until power supply OFF

F dial

Auto return off

Film tip left

Aperture switches between stopped down and open each time button is pressed

CAF

On

F dial and

R dial

Link to zooming

Until setting

cancelled

Set with F dial while pressing LIGHT button

Function num- Detail number ber

Custom function setting mode

Turn the R dial to select “Function number”.

Turn the F dial to select “Detail number”.

Function number

Set the position dial to a position other than “CF”.

The custom function is set.

CLE: Resetting cus- tom functions

The custom functions (~) are always set to the standard settings.

•Note that if the exposure mode selector lever is set to any posi- tion other than “CF” at this time, all the custom functions are reset to the standard settings (i.e. to “0”).

Return the dial to “ ” (white) or “ ” (green) and take the photograph.

The display panel returns to the normal display.

*When using lenses for which the open aperture value (brightness) with zooming varies (eg. Vario Sonnar 28-80mm F3.5-5.6), the actual aperture is controlled by the camera so

that it assumes the value set with the aperture ring, rather than being controlled by zoom- ing. Set Custom Function to (1) to vary the aperture with zooming.

Detail number

•To initialize all set functions, display “CLE” as previously described in 2, and set to a position other than “CF”.

88 89