Aga Ranges F107411-01 manual Replaceing the Range, To Remove a Side Panel, To refit the draw

Models: F107411-01

1 32
Download 32 pages 26.29 Kb
Page 13
Image 13
Replaceing the Range

SERVICING  WARNING

Disconnect from electricity before servicing. Check appliance is safe when you have finished.

Replaceing the Range

Reverse procedure to reinstall the range and lower the front roller.

Make sure the anti-tip device is re-engaged properly when the range is replaced. Failure to take this precaution could result in tipping of the range and cause injury.

Reconnect the power supply

To refit the draw

To replace the drawer in the cooker, pull the side rails fully out.

Carefully move the drawer back between the rails and rest it on the side rails.

At each side hold the front of the drawer and pull the side rail forward so that the clips click into position holding the drawer to the side rails.

3. To Remove a Side Panel

Turn off the power at the circuit breaker.

Pull the range forward.

Pull off the push fit control panel end caps at each end and remove the end fixing screws under the end cap.

Remove the retaining screws for each panel (1 at the front and 2 at the rear). The lower front retaining screws (one each side) are situated beneath the lower edge at the front corners of the side panels

Reassemble in reverse order.

13

Page 13
Image 13
Aga Ranges F107411-01 manual Replaceing the Range, To Remove a Side Panel, To refit the draw, Servicing  Warning