SERVICING WARNING
Disconnect from electricity before servicing. Check appliance is safe when you have finished.
Servicing Notes
Disconnect from electricity supply before commencing servicing, particularly before removing any of the following: control panel, side panels, ceramic hob, or any of the electrical components or cover boxes. Before electrical reconnection check that the appliance is electrically safe.
1. To change oven light bulb.
Replacement bulb must be 15w
Turn off the power at the circuit breaker
Make sure the oven is cool. Open the oven door and remove the oven racks.
Unscrew the bulb cover by turning counter clockwise. It may be very stiff.
Taking care to protect your fingers in case the bulb should shatter, unscrew the old bulb.
Screw in the new bulb, screw back the bulb cover. Turn on the circuit breaker and check that the bulb now lights.
2 How to Move the Range for Servicing
Follow these procedures to remove appliance for servicing:
Turn off the power at the circuit breaker
The range is very heavy. Take great care. We recommend two people maneuver the range. Ensure that the floor covering is firmly attached, or removed to prevent it being disturbed when moving the range around. You will need the leveling tool.
Remove the drawer
Pull the drawer out to its furthest point.
Lift up the ends of the plastic clips (one each side) to release the catches holding the drawer to the side runners and at the same time pull the drawer forward and away from the side runners.
For safety’s sake push the drawer runners back out of the way. Put the drawer somewhere safe - do not refit it until you have finished, you will need access to the area behind the drawer.
Lower the front roller
Fit the leveling tool on the rectangular adjuster as shown.
Lower the front roller by turning the leveling tool clockwise until the front feet are just clear of the floor.
Slide range forward to disengage the range from the
Disconnect electrical supply to appliance and unplug the electrical supply cord.
12
