35 U104613-03

Read all instructions before installing or using this appliance.
Installation Instructions
Save these instructions for future reference.
Installation Safety Instructions

Warning!

Improper installation, adjustment, alteration,
service or maintenance can cause injury or property
damage. Refer to this manual. For assistance or
additional information, consult a qualified installer,
service agency, manufacturer (dealer) or the gas
supplier. Never reuse old flexible connectors.
The use of old flexible connectors can cause gas
leaks and personal injury. Always use NEW flexible
connectors when installing a gas appliance.

Important

Remove all packing material and literature from
oven before connecting gas and electrical supply to
range.
• Have your range installed by a qualified installer.
• Your range must be electrically grounded in
accordance with local codes or, in the absence
of local codes, in accordance with the National
Electrical Code (ANSI/NFPA 70, latest edition).
• Before installing your range on linoleum or any
other synthetic floor covering, make sure the
floor covering can withstand 180°F without
shrinking, warping or discoloring. Do not install
the range over carpeting unless a sheet of 1/4’’
thick plywood or similar insulator is placed
between the range and carpeting.
• Make sure the wall coverings around the range
can withstand heat generated by the range up to
200°F.
• Avoid placing cabinets above the range. There
must be a gap of at least 30'' (76cm) between the
top of the range and any combustible surface
above it.
If a ventilating hood is installed above the range
follow the installation instructions supplied with
the hood.

Caution

Items of interest to children should not be stored
above a range - children climbing on the range to
reach items could be seriously injured.

Converting to LP Gas

This appliance is supplied set for Natural gas.
A conversion kit for Propane gas is supplied with
the range.
If the appliance is to be converted this must be
done before installation. The conversion must be
performed by a qualified LP gas installer. See the
Conversion section at the back of this installation
manual for more details.