37 U104613-03
Read all instructions before installing or using this appliance.
Installation Instructions
Save these instructions for future reference.
fresh air for combustion and ventilation are not
obstructed by carpeting or woodwork.
Your range is heavy and can settle into soft floor
coverings such as cushioned vinyl or carpeting.
Use care when moving the range on this type of
flooring. It is recommended that the following
simple and inexpensive instructions be followed to
protect your floor.
The range should be installed on a sheet of
plywood (or similar material). When the floor
covering ends at the front of the range, the area
that the range will rest on should be built up with
plywood to the same level or higher than the floor
covering.
This will allow the range to be moved for cleaning
or servicing. Also, make sure your floor covering
will withstand 180°F. (See the Installation Safety
Instructions section.)
Make sure the wall coverings around your range
can withstand the heat generated (up to 200°F) by
the range. (See the Installation Safety Instructions
section.)
Moving the Range
The range is very heavy. Take great care.
We recommend two people maneuver the range.
Ensure that the floor covering is firmly attached,
or removed to prevent it being disturbed when
moving the range around. You will need the
leveling tool.
From the back tilt the range forward and remove
the rear half of the polystyrene base pack.
Repeat from the front and remove the front half of
the polystyrene base.
LOWER THE TWO REAR ROLLERS.
First fit the leveling tool on the hexagonal adjusting
nut as shown below.
Make 10 complete (360º) turns clockwise. (This
means turning and removing the leveling tool 20
times).
Make sure you lower BOTH REAR ROLLERS. There
are two adjusting nuts, one for each roller, at both
the front bottom corners of the range.

Note the rollers are only intended to aid

installation - the range should not be moved

once it is installed.

Unfold the rear edge of pack base tray. Open the
broiler door and the Tall oven door. Grip under the
control panel and lift the front of the range.