U104613-03 44

Read all instructions before installing or using this appliance.
Installation Instructions
Save these instructions for future reference.
Fit a squeeze connector (not supplied with the
range), to your conduit. Insert the conduit through
the reducer plates on the mounting bracket. Allow
enough slack to easily attach the wires to the
terminal block.
NOTE: Do not install the conduit without a squeeze
connector.
A Ground strap is supplied in the conversion pack.
ground strap.
Fit the Ground strap to the ground and center
terminal of the connector block - see the figure.
The neutral or ground wire of the power cord must
be connected to the neutral terminal located in
the center of the connector block. The power leads
must be connected to the outside terminals.
NOTE: Make sure the wires are completely inserted
into the terminals and secure connections are
made.
Secure the squeeze connector in place in the
bracket by tightening the squeeze connector
screws.

Seal the Openings

Seal any openings in the wall behind the range
and in the floor under the range when hookups are
completed.

When all Connections are Completed

MAKE SURE THE FLOW OF COMBUSTION
AND VENTILATION AIR TO THE RANGE IS
UNOBSTRUCTED.
Assemble the range

Fit the Door Handles

Remove the 4mm Hex headed screws from the
doors with the hexagon key tool. Use the screws to
fit the door handles.
The handles should be above the fixings.
Fit the plastic blanking plugs to the fixing holes.

Fit the Handrail

Remove the 4mm Hex headed screws from the top
corners of the fascia.
Fix the front handrail in position. Fit the plastic
blanking plugs to the fixing holes.