Some basic operations
Make sure the unit is turned on. Use either the front panel keys or the corresponding SCPI commands.
The column on the left indicates the front panel keys that program the indicated action. If the SCPI programming syntax is substantially different from the front panel menu command, it is shown inside parentheses ( ).
The text to the right describes the result. If appropriate, the resultant output waveshape is shown underneath the description.
Enable the output
Output On/Off
When the output is enabled, the programmed voltage appears at the output and the Dis annunciator turns off.
Select the output phase (Agilent 6834B only)
Phase Select
(INST:NSEL)
You can specify phases individually, or you can couple the phases. When phases are coupled, all three phase annunciators (φ1, φ2, φ3) on the front panel are on, indicating that commands will be sent to all three phases.
Note that front panel metering is only done one phase at a time (except for the total power and neutral current measurements).
Set the voltage
Voltage | When this command is sent, the output voltage is set to 120 V rms. |
1
2
0
VOLT 120 | 0 V | 120 V rms |
Enter |
|
|
Set the frequency
Freq
5
0
When this command is sent, the output frequency is set to 50 Hz.
FREQ 50
Enter
120 V rms
60 Hz | 50 Hz |
9