■CLEANING INFORMATION
The following Cleaning Instructions contain some general safety precautions, which must be observed during all phases of cleaning. Consult your specific optical device manuals or guides for full information on safety matters.
Please try, whenever possible, to use physically contacting connectors, and dry connections.
Clean the connectors, interfaces, and bushings carefully after use.
If you are unsure of the correct cleaning procedure for your optical device, we recommend that you first try cleaning a dummy or test device.
Agilent Technologies assume no liability for the customer's failure to comply with these requirements.
For more information about Cleaning Instruments, please consult the Pocket Guide "Cleaning Procedures for Lightwave Test and Measurement Equipment" (Agilent P/N
Safety Precautions
Please follow the following safety rules.
■Do not remove instrument covers when operating.
■Ensure that the instrument is switched off throughout the cleaning procedures.
■Use of controls or adjustments or performance of procedures other than those specified may result in hazardous radiation exposure.
■Make sure that you disable all sources when you are cleaning any optical interfaces.
■Under no circumstances look into the end of an optical device attached to optical outputs when the device is operational. The laser radiation is not visible to the human eye, but it can seriously damage your eyesight.
■To prevent electrical shock, disconnect the instrument from the mains before cleaning. Use a dry cloth, or one slightly
N3970A
39
