Agilent Technologies N3970A manual Storing & Recalling Readings, Memory operating sequence

■STORING & RECALLING READINGS

The memory location is shown at the top right of the display.

When storing data, the memory automatically increments to facilitate the collection of data on a job.

You can also go back and over-write particular records.

After the data has been recorded, the entire memory can be cleared ready for the next job.

Memory operating sequence

Store data in next location: push STORE

Store data starting at a particular location: push SELECT, +/-,

SET, STORE

The memory can not be read in Autotest mode. Exit Autotest before reading the memory.

Read from any location: push RECALL, +/-. To display the relative value, push ABS/REL, and to display the reference, hold down ABS/REL.

Clear the whole memory: push CANCEL and RECALL together for 2 seconds. CLR will display.

N3970A UM-1

17