Agilent Technologies N3970A manual Optical Connector

■OPTICAL CONNECTOR

The optical port is mounted on a swivel, which allows the connector to be angled outwards for accessibility, and then pushed back and covered with the snap cover to provide dirt and drop protection.

The other port can be used to store a spare interchangeable optical connector.

To install the connector adaptor, align the locating slot on the side of the adaptor with that on the instrument connector, and push it on.

To remove the connector adaptor, move the connector port to it’s mid-way point (see dotted line on diagram at back of manual), and then pull off the adaptor. It is not possible to remove the adaptor in the ‘open’ or ‘shut’ positions. With some styles of connector, it is easier to pull off the adaptor with a test lead in place, since this gives better grip.

Different styles of connector adaptor ( ST, SC, FC, ) can be easily fitted by the user.

Optical connectors are precision components, and require care in use:

■Always clean the mating connector tip and ferrule before mating, using approved materials.

■This instrument can be used with both PC and APC connector styles (unlike sources, which are factory configured for PC only ).

■The soft carry case enables the instrument to be stored without removing the test leads. This practice saves time, and is to be recommended.

■When not in use, keep all test ports and connectors covered and away from dust.

■Do not touch connector tips with your fingers, since body oils and dirt can impair connector performance.

■Do not use damaged or incompatible connectors.

N3970A UM-1

9