All Channels, Store current setting | Agilent Technologies N5980A

Programming Reference

Store current setting

:MMEM:STOR:STAT “filename”

Syntax :MMEM:STOR:STAT “filename”

Description Stores the current setting into the specified file. If a file with the same name already exists, then this file will be overwritten.

Recall setting

:MMEM:LOAD:STAT “filename”

Syntax :MMEM:LOAD:STAT “filename”

Description Loads stored instrument setting from the given file.

All Channels

Datarate

:FREQ Syntax :FREQ?

:FREQ FE

OC3OC12OC48OC48FECFC1FC2GBE1XAUI Description Either sets or gets the instrument’s datarate. The datarate

always applies to all the channels (electrical out, optical out, clock out, and error detector input).

Available Data Rates	Name	Frequency	Parameter
	Fast Ethernet	125.00Mb/s	FE
	OC-3	155.52Mb/s	OC3
	OC-12	622.08Mb/s	OC12
	OC-48	2.48832Gb/s	OC48
	OC-48 with	2.666Gb/s	OC48FEC
	FEC
	1 x FC	1.0625Gb/s	FC1
	2 x FC	2.125Gb/s	FC2
	Gigabit	1.25Gb/s	GBE1
	Ethernet
	XAUI	3.125Gb/s	XAUI

N5980A User Guide

33

Image 33

Agilent Technologies N5980A manual All Channels, Store current setting, Recall setting, Datarate

Contents

Agilent 125 Gb/s Serial Bert Herrenberger Str Revision 1.0 May Safety Summary Environmental Information Contents Programming Reference Introduction CD content is Inspect ShipmentSerial Bert Front Panel Connect the Instrument To Connect N5980A Rear Panel Serial Bert setup diagram Install User Software for N5980A To Install the User Software for N5980A Select the folder in which N5980A will be saved To Access N5980A Demo Offline Introduction Advanced Mode Running the BER Test Setup Setting the Instrument Parameters Advanced BER displays Gating BER and the Elapsed Gating Time Viewing the Results Advanced Mode Store SettingFile Menu Connection Menu Each PC can control only one N5980A Connect Error Indicators Help MenuInfo Error BER BarSync Loss Setup and Advanced Tab GeneralGenerator Input Error DetectorSFP Data Pattern SMA Data Pattern Gating BER Bar BER and Advanced BER Tab Actual Errors Gating ErrorsError Detector Pattern Advanced BER Agilent N5980A Command Summary Common Command Summary Scpi Instrument Command List- Reference Common CommandsID Query Load factory default setting Read error queueOperation complete Option Query Recall setting Store current settingAll Channels Datarate Pattern SMA Output Electrical GeneratorSOUR1PATT Either sets or gets the pattern of the SMA output Add Single Error Error InsertionInsertion Rate Output Level SFP Output Optical Generator SOUR2PATTEither sets or gets the pattern of the SFP output SOUR2PATTEADDRATE SOUR2PATTEADD OnceSyntax SOUR2PATTEADD Once Detected Pattern Trigger OutputSOUR3PATT SENS1PATT? Synchronization mode Actual Bit Error RateActual Number of Errors Gating Number of Errors Gating Bit Error RateGating Time Start Gating Gating Progress Description Selects the input for the error detectorInput Selection SENS1INP Sample Code Communicate with the instrument Programming Reference