Aiwa AV-D30 manual Selection Of Audio/Video Source, Select the program source, English

SELECTION OF AUDIO/VIDEO

SOURCE

1

/r’

1 Select the program source.

Press one of the function buttons or the TAPE MONITOR button.

To change a displayed name for the VIDEO 1/5.1 CH button and VIDEO 2 button

Wtien the VIDEO 1/5.1 CH button is pressed, VIDEO 1 is ‘

displayed initially. It can be changed tO DVD or MD.

With the power on, press the POWER button while pressing the VIDEO 1/5.1 CH button.

This VIDEO 1/5.1 CH button also works as the 5.1 CH (5.1 INPUT) function switch. While the selected function name (VIDEO 1, DVD or MD) for the VIDEO 1/5..1 CH button is displayed, press the button again. The function name will change to “5.1CH” and the source connected to the 5.1 INPUT terminals is selected.

To resume, press the button again so that the selected function name is displayed.

The displayed name for VIDEO 2 button can be changed to ~ VIDEO 2, LD orTV with the power on, press the POWER button

while pressing the VIDEO 2 button.

To adjust the sound level of the connected source

The input sensitivity level of each function (except the TUNER and 5.1 CH functions) can be adjusted.

When the sound level of the connected source is higher or lower ‘

TapeTAPE”MONITOR

than that of the TUNER, adjust it as follows.

,,

RadioTUNER

RecordPHONO

LD or Cable TV	VIDEO	2
MD or DVD	VIDEO	1/5.1 CH

The function buttons to be pressed (except PHONO) depend on the equipment connected to the input terminals on the rear panel of the unit.

m

When using a turntable with a built-in equalizer amplifier, set the switch of the equalizer amplifier to off. See the instructions of the turntable for further information.

2 Start the selected program source.

3 Adjust the sound.

About the video source to the monitor or TV

I

Selected VIDEO source

V1 : VIDEO 1, V2: VIDEb 2, V3: VIDEO 3

The selected video source is indicated on the display and the video signal through the MONITOR VIDEO OUT jack is output on the TV.

9 ENGLISH

1 Select the function to be adjusted.

Press the function button accordingly and play the source.

2 Press the UPA or DOWNV button repeatedly.

The level can be adjusted between -6dB (MIN) and +8dB (MAX) in 2dB steps. Adjust the level so that the sound is output at the same level as the TUNER.

m

●The input sensitivity level of the TUNER or 5.1 CH function cannot be adjusted.

●That of the TAPE MONITOR cannot be adjusted either.

Even if the TAPE MONITOR is selected and the TAPE MONITOR indicator turns red, pressing the UPA or DOWNT button will change the level of the function displayed on the window.

.,