Aiwa AV-D30 manual Manual Tuning, Direct Tuning, Press the UPA or DOWNY button to select a station

MANUAL TUNING

1 Press the TUNER button repeatedly to select the desired band.

~

The display changes to frequency indications after indicating band and video source (V1, V2 or V3) for two seconds.

When the TUNER button is pressed while the power is off, the power is turned on directly.

2 Press the UPA or DOWNY button to select a station.

Each time the button is pressed, the frequency changes. When a station is received, “TUNE” is displayed for two seconds. During FM stereo reception, [{(m)]) is displayed.

To search for a station quickly (Auto Search)

Keep the UPA or DOWNT button pressed until the tuner starts searching for a station. After tuning in to a station, the search stops.

To stop the Auto Search manually, press the UPA or DOWNY button,

●The Auto Search mqy not stop at stations with ‘“veryweak signals.

When an FM stereo broadcast contains noise

Press the MONO TUNER button on the remote control so that “MONO appears on the display.

Noise is reduced, although reception is monaural.

To restore stereo reception, press the button so that “MONO?’ disappears.

DIRECT TUNING

f?====%

I

DOWNY, UPA

When you know the frequency of the desired station, you can tune in directly to the station.

1 Press the TUNER button to select a band.

2 Press the TUNER button and hold it down until “.....“flashes on the display (DirectTuning Mode).

3 Press the appropriate numbered buttons,to tune in to the desired station.

Example:

To tune in to 106.50 MHz, press 1, 0, 6, 5 and O buttons. To tune in to 95.20 MHz, press 9, 5, 2 and Q buttons.

To cancel the Direct tuning mode

Press the UPA or DOWNY button.

When using the remote control

Carry out steps 1 and 2 above, and press the numbered buttons on the remote control to tune in to the desired station.

●When entering a frequency out of tuning range, the value flashes for two seconds and then goes off. Check the frequency and repeat step 3 correctly.

●When entering” a frequenc~ not covered by the tuning interval, the value is automatically rounded up or down to the closest one covered by it.

To change the AM tuning interval

The default setting of the AM tuning interval is 10 kHz/step. If you use this unit in an area where the frequency allocation system is 9 kHz/step, change the tuning interval.

Hold down the TUNER button and press the POWER button immediately. Note that the unit is set to the Direct Tuning mode if the TUNER button is pressed and held down for about half a second.

To reset the interval, repeat this procedure.