Aiwa CX-NA22 manual Setting The Clock, Setting The Sleep Timer, ~acica

SETTING THE CLOCK SETTING THE SLEEP TIMER

au

1

~acica

2.

1 Press the CLOCK button while pressing the SHIFT button on the remote control, and press the 11SET button within 4 seconds.

2 Press the + DOWN or - UP button to designate the hour, and press the II SET button.

The hour, stops flashing and the minute starts flashing.

3 Press the + DOWN or - UP button to designate the minute, and press the II SET button.

The minute stops flashing on the display and the clock starts from 00 seconds.

To display the current time

Press the CLOCK button while pressing the SHIFT button on the remote control. The time is displayed for 4 seconds. However, the time cannot be displayed during recording.

To switch to the 24-hour standard

Press the CLOCK button while pressing the SHIFT button on the remote control and then press the ■ button within 4 seconds. Repeat the same procedure to restore the 12-hour standard.

If the clock display flashes

This is caused by a power interruption. The current time needs to be reset.

If power is interrupted for more than approximately 24 hours, all settings stored in memory after purchase need to be reset.

The unit can be turned off automatically at a specified time.

Use the remote control.

1 Press the SLEEP button while pressing the SHIFT button.

2 Within 4 seconds, press the < or - button to specify the time until the power is turned off.

Each time the button is pressed, the time changes between 5 and 240 minutes in 5-minute steps.

Specified time

To check the time remaining until the power is turned off

Press the SLEEP button once while ~ressinq the SHIFT button. The remaining time is displayed for 4 secon&.

To cancel the sleeptimer

Press the SLEEP button twice while pressing the SHIFT button so that “SLEEP on the display disappears.

.