Aiwa CX-NA22 manual Setting The Timer, Timer Recording, Designate the hour of the timer-on time by

SETTING THE TIMER

4

1

1,2

.3

‘

2,4

5

u 6

The unit can be turned on at a specified time every day ‘with the built-in timer.

Preparation

Make sure the clock is set correctly,

Use the remote control.

1 Press the TIMER button while pressing the SHIFT button once to display 0, and press the 11 SET button within 4 seconds.

O is displayed, and the hour flashes.

o

m’

If you press the 11 SET button after 4 seconds, another operation may start.

2 Designate the hour of the timer-on time by

pressing the < DOWN or _ UP button, and press the 11 SET button. Repeat to designate the minute of the timer-on time.

To listen to the ;adio, tune in to a station.

6Press the POWER button to turn the unit off after adjusting the volume and tone.

O remains on the display after the power is turned off (timer standby mode).

When the timer-on time is reached, the unit turns on and begins play with the selected source.

The volume level is automatically set to 16 when the power is turned off with the volume level set to 17 or more,

To check the specified time and source

Press the TIMER button while pressing the SHIFT button. The timer-on time, the selected source name and the duration for ❑ the timer-activated period are displayed for 4 seconds.

To cancel timer standby mode temporarily

Press the TIMER button repeatedly while pressing the SHIFT button so that O disappears on the display.

To restore the timer standby mode, press again to display ~.

Using the unit while the tinner is set

You can use the unit normally after setting the timer.

Before turning off the power, carry out step 5 to prepare the source, and adjust the volume and tone.

After you designate the timer-on time, one of the source name flashes on the display for 4 seconds.

3 Within 4 seconds, press the FUNCTION button repeatedly to select a source.

The selected source name flashes for 4 seconds.

●If this step is not completed within 4 seconds, repeat from step 1.

●If the TUNER button is pressed, the band cannot be selected in this step.

TIMER RECORDING

Timer recording is applicable for TUNER and VIDEO/AUX (with an external timer) sources only.

Press the TIMER button repeatedly while pressing the SHIFT button so that @ flashes on the display, and press the II SET button within 4 seconds. Flepeat the steps shown above from step 2 and insert the tape to be recorded into deck 2 after step 5.

m

●Timer playback and timer recording will not begin unless the power is turned off.

●Connected equipment cannot be turned on and off by the built- in timer of this unit. Use an external timer.

ENGUS/-/ 16