SETTING THE TIMER
1
2,43
1,2
6
The unit can be turned on at a specified time every day with the
Preparation
Make sure the clock is set correctly, (See page 5.)
Use the remote control.
1 Press the TIMER button on the remote control once to display 0, and press the II SET button within 4 seconds.
~is displayed, and the hour flashes.
If you do not press the 11SET button within 4 seconds, another operation may start.
2 Designate the hour of the
After you designate the
3 Within 4 seconds, press one of the function buttons to select a source.
“TIMER”and the selected source name flash alternately for 4 seconds. At this time, the selected function button does not light up.
●If this step is not completed within 4 seconds, repeat from step 1.
●If the TUNER button is pressed, the band cannot be selected in this step.
4 Within 4 seconds, select the duration for the
UP button.
The duration for the
●If this step is not completed within 4 seconds, repeat from step 1.
5 Prepare the source.
To listen to a CD, load the disc to be played first on tray 1. To listen to a tape, insert the tape into deck 1 or 2.
To listen to the radio, tune in to a station.
6Press the POWER button to turn the unit off after adjusting the volume and tone.
@ remains on the display after the power is turned off (timer standby mode).
When the
To check the specified time and source
Press the TIMER button on the remote control. The
TIMER RECORDING
Timer recording is applicable for TUNER and VI DEO/AUX (with
an external timer) sources only.
Press the TIMER button twice on the remote control so that
.~ appears on the display, and press the 11SET button within 4 seconds. Repeat the steps shown above from step 2 and
insert the tape to be recorded into deck 2 after step 5.
To cancel timer standby mode temporarily
Press the TIMER button on the remote control so that @ or Q disappears on the display.
To restore the timer standby mode, press again to display @ or m
Using the unit while the timer is set
You can use the unit normally after setting the timer.
Before turning off the power, repeat step 5 to prepare the source,
and adjust the volume and tone.
●Timer playback and timer recording will not begin unless the power is turned off.
●Connected equipment cannot be turned on and off by the built- in timer of this unit. Use an external timer.
19