Aiwa CX-ZL10 Press, SLEEP, 3 Press, To view, in the display, Specified time, The remaining time, Use the remote control, Use the remote control, To cancel the sleep timer

-. /,

[+Tj.. .—. -i~J... (J.

w

When the clock is set, the “:”between the hours and minutes flashes. When the power cord is plugged into an AC outlet for the first time after purchase or when the clock setting is canceled due to a power failure, the entire clock display flashes.

Use the remote control.

1 Press CLOCK once while pressing SHIFT on the remote control.

2

The unit can be turned off automatically at a specified time.

Use the remote control.

1 Press SLEEP while pressing SHIFT on the remote control.

2 Within 4 seconds, press 4 or -to designate the hour and the minute.Holding these buttons down will vary the time rapidly.3 Press II.The clock starts from 00 seconds.To view the clock when another display is in the display

Press CLOCK while pressing SHIFT. The time is displayed for 4 seconds and then the original display reappears. However, the clock cannot be displayed during recording.

To switch to the 24-hour standardPress CLOCK once while pressing SHIFT and then press ■ within 4 seconds.Repeat the same procedure to restore the 12-hour standard.

If the display flashes when the clock is displayed, it indicates that the clock has stopped due to a power failure or the removal

of the power cord. The current time needs to be reset.

~

2 Within 4 seconds, press + or -10 specify the time until the power is turned off.

The time “changesbetween 5 and 240 minutes in 5-minutf? steps.Specified timeWhile the sleep timer is in operation, the display is dimmer than usual.

To check the time remaining until the power is turned off Press SLEEP once while pressing SHIFT. The remaining time

is displayed for 4 seconds.To cancel the sleep timer

Press SLEEP twice while pressing SHIFT so that “SLEEF’OFF” appears on the display.

~6 ENGLISH