SETTING THE CLOCK | SIMPLE AUDIO ADJUSTMENT |
CLOCK
BBE
GEQ
PHONES
When the AC cord is connected for the first time, the El SET button flashes.
Set the time as follows while the power is off.Press the 1MSET button.The hour flashes.
Press the l<< DOWN or ›~1 UP button to designate the hour,Press the II SET button to set the hour.The hour stops flashing and the minute starts flashing.
Press the 1<4 DOWN or WI UP button to designate the minute.Press the RI SET button to set the minute and complete setting.The minute stops flashing on the display and the clock starts from 00 second.
To correct the current timePress the POWER button to turn the unit off. Press the II SET button and carry out steps 1 to 5 above.
To display the current timePress the CLOCK button on the remote control. The clock is displayed for 4 seconds,
However, the time cannot be displayed during recording.
To switch to thePress the CLOCK button on the remote control and then press the 9 button within 4 seconds.
Repeat the same procedure to restore the
This is caused by a power interruption. The current time needs to be reset.
If power is interrupted for more than approximately 24 hours, all settings stored in memory after purchase need to be reset.
VOLUME
Turn the VOLUME control on the main unit, or press the VOLUME buttons on the remote control.
To change the Iefthight balanceTurn the BALANCE control.
BBE SYSTEM
The BBE system enhances the clarity of |
|
It also enriches the KARAOKE function to make your voice sound |
|
clear and pleasant. |
|
Press the BBE button. |
|
Each time it is pressed, the level changes, Select one of the | ❑ |
three levels, or the off position to suit your preference. |
SUPER T-BASS SYSTEM
The
Each time it is pressed, the level changes. Select one of the three levels, or the off position to suit your preference.
m
Low frequency sound may be distorted when the
ENGLISH 6