2 Interfacing |
You may connect any AKG phantom power sup- | 2.2.2 Connecting |
ply (2) to an unbalanced input, too. | to Unbalanced |
Use a cable (3) with a female XLR connector and | Inputs |
TS jack plug: | Refer to fig. 2. |
MPA | Phantom |
Fig. 2: Connecting to an unbalanced input.
1.On the XLR connector (4), use a wire bridge to connect pin 1 to pin 3 and the cable shield.
2.Connect the inside wire of the cable to pin 2 on the XLR connector (4) and the tip contact of the jack plug (5).
3.Connect the shield of the cable to the shaft contact on the jack plug (5).
Unbalanced cables may pick up interference Note: from stray magnetic fields near power or lighting cables, electric motors, etc. like an antenna.
This may introduce hum or similar noise if you use a cable that is longer than 16 feet (5 m).
☞
15
