ASSEMBLY
ASSEMBLY
GENERAL
To help you assemble your new SHD FLAIL to your tractor, we provide you with drawings, instructions, and information, if necessary, you may get more information or clarification from our Technical Services Department over the phone.
IMPORTANT
Reference to the left or right side of the SHD FLAIL is determined while facing the front of the tractor from the drivers seat.
Assemble the SHD FLAIL, step by step, as illustrated on the pages of this section. Small parts (bolts, nuts, etc.>) required are packed in numbered plastic bags which correspond to assembly procedures and illustrations in the manual.
The part quantities listed for an illustration pertain only to that phase of assembly. The quantity given corresponds to the number of parts needed.
Large parts are not always listed next to an illustration, but they are usually easy to identify.
Whenever reference is made to parts listed for an illustration or elsewhere in this manual, the following abbreviations are used:
When installing fasteners, PW and LW (generally installed in that order) are usually on the side of the fixture or part being fastened that the hex lock nut is on. When only BOLT, LW and/or PW are required, they are generally installed in that order. Some parts do not require a PW or LW. Refer to illustrations for exceptions. Fasteners should be installed so they cause the least interference with other parts. When securing driveshaft pulley to hub, tighten fasteners to
This manual makes reference to individual component parts, some of which may have been pre assembled at the factory.
SHD 03/09 | Assembly Section |
© 2009 Alamo Group Inc.
