(SG-7)

OPERATION

OPERATION

3. TRACTOR REQUIREMENTS

The tractor used to operate the mower must have the power, capacity and required equipment to safely operate the mower at a ground speed between 2 and 5 MPH. Operating the mower with a tractor that does not meet the following requirements may cause tractor or mower damage and could be a potential danger to the operator and passersby.

Tractor Requirements and Capabilities

ASAE approved Roll-Over Protective Structure (ROPS) or ROPS cab and seat belt.

Tractor Safety Devices

Slow Moving Vehicle (SMV) emblem, lighting, PTO master shield

Tractor Horsepower-Minimum

SHD62-20 HP, SHD74-35 HP, SHD88-40 HP, SHD96-50HP

3-Point Hitch-Lifting Capacity

SHD60-815 lbs., SHD72-930 lbs.,SHD88-1035 lbs., SHD96-1170 lbs.

Category

SHD60 - CAT I and SHD74, SHD88, SHD96, CAT I or CAT II

Front End Weights

As needed to maintain 20% weight on tractor front axle

Power Take Off

540 RPM-6 spline

3.1 ROPS and Seat Belt

The tractor must be equipped with a Roll-Over-Protective-Structure (ROPS) (tractor cab or roll-bar) and seat belt to protect the operator from falling off the tractor, especially during a roll over where the driver could be crushed and killed. Only operate the tractor with the ROPS in the raised position and seat belt fastened. Tractor model not equipped with a ROPS and seat belt should have these life saving features installed by an authorized dealer. OPS-U- 0003

Operate this Equipment only with a Tractor equipped with an approved roll- over-protective system (ROPS). Always wear seat belts. Serious injury or even death could result from falling off the tractor--particularly during a turnover when the operator could be pinned under the ROPS.

3.2 Tractor Safety Devices

If transporting or operating the tractor and implement near a public roadway, the tractor must be equipped with proper warning lighting and a Slow Moving Vehicle (SMV) emblem which are clearly visible from the rear of the unit. Lights and a SMV emblem must be equipped directly on implements if the visibility of the tractor warning signals are obscured.

Maintain all manufacturer equipped safety shields and guards. Always replace shields and guards that were removed for access to connect, service, or repair the tractor or implement. Never operate the tractor PTO with the PTO master shield missing or in the raised position. OPS-U- 0004

SHD 03/09

Operation Section 4-6

© 2009 Alamo Group Inc.

Page 92
Image 92
Alamo SHD96, SHD74, SHD62, SHD88 manual Tractor Requirements, Rops and Seat Belt, Tractor Safety Devices