Commissioning
Detailed description of RS commands
Syntax conventions applicable to all commands
Status values
Error messages
adr = address, from 000 to 255 <CR> Carriage Return (ascii 13)
<LF> Line Feed (ascii 10); shown in brackets as it is not compulsory.
ok : command executed correctly
Err0 : adjustment error (out of bounds)
Err1 : command error (syntax)
Err2 : parameter error (e.g.
Err3 : context error
Err4 : checksum error
ADR Specifies the address of the device for networking
Syntax #adrADRaaa<CR>[<LF>]
adr | = address of device before this command |
aaa | = new address of device |
condition | : 000 ≤ aaa ≤ 255 |
Result #aaa,ok or Err2
This command is used to allocate a specific number to each device on the network
(loop for RS232 or parallel for RS485).
Note: it is important to note the number allocated to each device.
January 2001
Alcatel Vacuum Technology France - ACT 250 addendum | 15 |
