Manuals / Brands / Laundry Appliance / Washer/Dryer / Alliance Laundry Systems / Laundry Appliance / Washer/Dryer

Alliance Laundry Systems 70278501R5EN Dual Digital Timer Control, QT and RQ Control Suffixes, When the cycle is complete, open door and remove the laundry

1 32

Download 32 pages, 910.22 Kb

Dual Digital Timer Control

QT and RQ Control Suffixes

1.Select HIGH, MED, LOW or NO HEAT by turning the temperature knob.

TMB2147N

Figure 13

2.Set the HEAT TIME for the number of minutes (from 0-60) desired.

TMB2148N

Figure 14

3.Set the COOL DOWN TIME for the number of minutes (from 0-15) desired.

TMB2149N

Figure 15

Installation/Operation Supplement

4.Select reversing or nonreversing cylinder rotation setting, if applicable.

TMB2145N

Figure 16

5.Press and release START button to start tumbler. Display will show minutes remaining before end of cycle.

TMB2150N

Figure 17

IMPORTANT: To stop the tumbler at any time during the cycle, OPEN DOOR. If the loading door or lint panel door is opened during the cycle, the heating system will shut off and the motor will stop. To restart the cycle, both doors must be closed and the START button must be pressed in.

6.When the cycle is complete, open door and remove the laundry.

70278501 (EN)

© Published by permission of the copyright owner – DO NOT COPY or TRANSMIT

25

Contents

Keep These Instructions for Future Reference (If this machine changes ownership, this manual must accompany machine.) www.comlaundry.com December Page WARNING Contents Introduction Model Identification Wiring Diagram Serial Plate Location Safety Information Save These Instructions Important Safety Instructions Page Specifications and Dimensions Cabinet Dimensions Horizontal Exhaust Outlet Locations Gas Connection Locations Electrical Connection Locations Steam Connection Locations Position and Level the Tumbler Fire Suppression System Water Requirements Water Connections Electrical Requirements Auxiliary Alarm Gas Requirements Natural Gas and Liquefied Petroleum European Gas General Information Page Exhaust Requirements Make-UpAir Venting Electrical Requirements Steam Requirements Thermal Oil Prep Steam Pressure Minimum Pipe Diameter Steam Trap Size bar (PSI) (Pounds Condensate/Hour) Operation Emergency Stop Button on CE Models Operating Instructions Step 1: Clean Lint Screen/Compartment Step 2: Load Laundry Control Instructions Electromechanical Coin Control CD and CX Control Suffixes Manual Timer Control MT and RT Control Suffixes Dual Digital Timer Control QT and RQ Control Suffixes Single Drop Control SD and SX Control Suffixes DMP OPL Control DO Control Suffix DMP OPL Features Programming Reversing Operation DMP Coin Control DV and DX Control Suffixes DMP Coin Features Ignition Control Operation Disposal of Unit